Create subnets that meet the host requirements using 192.168.0.0/24 24 means 8 host bits available for subnetting (N.N.N.H) o Staff 100 hosts 27-128 hosts, therefore only 7 host bits are needed, therefore you must borrow 1 bit creating a new SM 125. Furthermore, you will configure the SVI interface and basic security setting on switches S1, S2 and S3 You are also tasked with finishing the basic security settings and interface configurations on R1.
A Guest subnet will be added in the future to accommodate 25 hosts. The subnet for the rest of the staff requires 100 hosts. You have been tasked with ceting a new IPv4 addressing scheme that will accommodate 4 subnets using 192.168.0.0/24 network. In this example, the IP address is set to 160.168.1.0.
IPV6 SUBNET MASK TABLE HOW TO
The following XML output shows how to configure a single TCP/IP address.
IPV6 SUBNET MASK TABLE WINDOWS
Windows uses the default subnet mask of 255.0.0.0. In this example, the IP address is set to 10.168.1.0. The following XML output shows how to configure a single IP address. The IPv6 address is set to ffff:1::3, with a routing prefix length of 48. The IPv4 address is set to 192.168.1.0, with a routing prefix length of 25. The following XML output shows how to configure two static IP addresses. Microsoft-Windows-TCPIP | Interfaces | Interface | UnicastIpAddresses | IpAddress | Value Applies Toįor a list of the Windows editions and architectures that this component supports, see Microsoft-Windows-TCPIP. For IPv6 addresses, can be any value between 0 and 64. For IPv4 addresses, can be any value between 0 and 32. To define a routing prefix length, use the format: /. To use the default routing prefix length, use the format. Specifies the value of the IP Address, and routing prefix length. This element does not appear in the Properties pane of Windows System Image Manager (Windows SIM) until you add IpAddress to the unattended installation answer file.
If the routing prefix length is not defined, the default routing prefix length will be used, based on the class of the IP address.ĭefault routing prefix lengths and subnet masks for IPv4 addresses Class A subnet mask is a bit mask covering the number of bits used in the prefix. The routing prefix length refers to the number of leading bits in the IP address.
It can also optionally specify a routing prefix length, which is often expressed as a subnet mask. Value specifies the value of the IpAddress.
0 kommentar(er)
